In recent years, the domestic production of cemented carbidebars has been increasing, but as demand continues to expand, the market is in short supply, and its quality inspection requirements are also facing difficulties. At present, the detection of cemented carbidebars in China generally adopts manual methods, which consumes more manpower and unstable test results. The automatic inspection equipment is gradually favored by the majority of manufacturers.

According to relevant data, cemented carbidebar has a series of excellent properties such as high hardness, high wear resistance, high strength, bending resistance and long service life of carbide tool. cemented carbidebar is a kind of blank for making drill bits and tools. At present, powder extrusion forming technology is adopted. Now widely used in the production of automobile, tool bit, printed circuit board, the whole engine tool tool, milling cutter, reamer overall, carving knife and so on, but also can produce punch, mandrel, top and perforating tool. With the rapid increase of market demand, ultra-fine grained carbide bars have been used more and more widely. In the field of high speed cutting, due to the high safety requirements of the safety, reliability and durability of the tool, the quality requirements of the internal and surface of the whole cemented carbide tool are more stringent. With the continuous improvement of the internal quality of cemented carbide bars, especially superfine cemented carbides, the quality of cemented carbide tools has been paid more and more attention to.

Itis a kind of product with high requirement of cemented carbide bars material. Oxygen content is considered as a harmful substance in cemented carbide mixture. Whether the water in the atmosphere or reconcile drying is the mixture of oxidation to the extreme, in violation of the normal quality control principle, what is the purpose? The reason is: the production of cemented carbide in the production process control, the biggest difficulty is the balance of carbon and oxygen, the experimental analysis shows that the material on the degree of oxidation and to 3 days 7 days, 15 days to 30 days the oxidation degree is different, but 30 days later after the oxidation of saturated very long almost no change. Therefore, if the degree of oxidation is increased directly to saturation, the method of increasing carbon content should be adopted, and the process control of carbon and oxygen balance will be easy. This process is the control of such cheap operation. This is the biggest feature and advantage of this process.

The structure of the products of the chemical production process is normal, the physical properties of the low quality, the key technology is not a problem in itself but the process needed to do not have the conditions at home and abroad: technology developed, due to environmental constraints, the use of water as a carrier, if the use of water as the carrier, must improve the original carbon the content of the compound WC. While the domestic WC in carbonization when the composite carbon to a certain extent, it will be difficult to improve, for example, when your WC total carbon is 6.2%, may be free carbon is 0.5%, composite original carbon only 6.15%. Carbonation has not yet been achieved, so at present, the carbide alloy bar adopts this process is to use C black in ball milling to improve the total carbon content, free carbon is unable to restore, part of WC is oxidized.

Find more information out online at www.wococarbide.com

Posted by: hannahgwendolyn at 09:57 AM | No Comments | Add Comment
Post contains 581 words, total size 4 kb.