Four Flower Swarovski Crystal Rings How to make beautiful swarovski crystal ring, using the crystal beads, Czech as well. It is quite easy to make from scratch; you can do it in three steps. The base is made with Czech beads and the top with Swarovski crystals then the band of the ring. I will explain the three steps, it is so beautiful to wear out - a bit of bling-bling is all you need to set off a nice outfit as an accessory. 12 Czech crystal beads 4mm 16 Swarvoski crystal 4mm beads Seed beads No 8 or Jap beads Fishing line thin one 0,20mm The base is easy to make using the Czech beads in 4mm; you use fly fishing line, which is pretty thin 0,20mm or the thinnest you can get. Then you put 4 Czech crystal beads on a some of the fishing line, the 4th bead you put one thread through the top bead, my popular sterling silver swarovski crystal ring is the one that has the four flowers on, so you need 12 Czech crystal beads to do it, so add 3 more onto the 4 you have done, this time make sure the one where both threads go through is on the right or the left, I am left-handed so you will have to see. Then add another three Czech beads on put threads through bottom now, so it goes down taking the form of a square, put thread through the one from the original one you started, add the last two crystal beads. Now on to the four flowers using Swarovski crystals, you can probably use Czech Crystals on top as well, up to you entirely. You should have 2 threads coming from either end of the Czech bead. You will need 16 Swarovski crystal beads in 4mm, whatever colors you decide to use. Thread one crystal on thread a small seed bead size 8 or Jap bead, then another 4mm crystal, put the thread through the bottom Czech bead opposite side to top end. Now take another crystal ring on to the remaining thread put the thread through the small seed bead then add another crystal put the thread through the other end. Keep going until you have 4 flowers; make sure you go through the seed bead in the same direction for all four. Finish off by putting seed beads between the Czech beads on the sides, then finish off with a double know or doctors knot, put a dash of glue or nail varnish, sew away the remaining threads through the beads so none showing.You can make the band using the seed beads I normally make a double row band or whatever is easiest.

Posted by: hannahgwendolyn at 05:54 AM | No Comments | Add Comment
Post contains 460 words, total size 3 kb.